Rinnai HD210i, Installation Manual

Page: 4 / 16

Rinnai 4 HW_CF_FFPP_FIM
WARNING
BEFORE USING INSTALLING FLUE COMPONENTS
Before proceeding with the installation of an FFPP coaxial flue system, read this manual
thoroughly to gain a full understanding of the installation requirements.
Always comply with the following precautions to avoid dangerous situations and to ensure
optimum performance.
Failure to carefully read and follow all instructions in this manual can result in equipment
malfunction, property damage, personal injury and/or death.
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in
personal injury or death.
WARNINGS: Indicates a potentially hazardous situation which, if not avoided, could result in
personal injury or death.
CAUTIONS: Indicates a potentially hazardous situation which, if not avoided, could result in
minor or moderate injury or damage to the appliance. It may also be used to alert against unsafe
practices.
WARNING
REGULATORY INFORMATION
Your Rinnai gas continuous flow water heater flue has been certified by the Australian Gas
Association. The A.G.A. Certification Number is shown on the data plate.
These flueing components
MUST be installed in accordance with:
•
Current AS/NZS 3500 and AS/NZS 5601
•
The installation MUST comply with all relevant instructions supplied by Rinnai.
•
Service and removal MUST be carried out by an authorised person.
•
Local regulations and municipal building codes including local OH&S requirements
Flue components MUST be installed correctly by an appropriately licensed tradesperson. The
installation of gas, water, and electricity must conform to local regulations.
All dimensions referred to in these instructions are in millimetres, unless otherwise specified.
These instructions
ONLY apply to the Rinnai FFPP water heater coaxial flueing system. This flue
system utilises Polypropylene pipe components for both the outer (white) and inner (grey) pipes.
These instructions
DO NOT apply to older Rinnai water heater flueing that has either a stainless
steel single skin or aluminium coaxial construction. If in doubt contact Rinnai.
Before commencing installation, please read the 'Installation Instructions - General', located
inside a pouch behind the front cover of all Rinnai water heater models. The Rinnai internal
water heater range must only be installed with Rinnai water heater flueing as referred to in these
instructions.
Appliances are certified to be installed side by side as shown on page 6. Refer to the operation
and installation manual provided with the appliance for clearance details pertaining to single
appliance installations.
A Rinnai internal continuous flow water heater fitted with an FFPP flue system is room sealed as
defined in AS/NZS 5601. No ventilation in the space where the water heater is installed is required.
The outer plastic section of the coaxial flue complies with temperature hazard requirements and
can be installed with zero clearance to combustible material.
Notice to Victorian Consumers
The appliance and flue components MUST be installed by a person licensed with the Victorian
Building Authority. ONLY a licensed person will have insurance protecting their workmanship.
So make sure you use a licensed person to install this appliance and ask for your Compliance
Certificate.
For further information contact the Victorian Building Authority on 1300 815 127.
WARNINGS & IMPORTANT INFORMATION