– 28 –
PRE-SERVICE CHECK
Before asking for a service call please check the following.
These points are part of the normal operation of the unit.
At ignition :
Warm air does not start when the burner
lights.
The fan is started automatically after a short delay.
This is to allow the heat exchanger to warm up,
helping to avoid cold draughts.
During combustion :
Clunking noise when the thermostat
operates.
This is the sound of the solenoid gas valves opening
and closing.
When the unit is turned off :
Convection fan continues to run after
turning off.
This is to remove the residual heat from the heat
exchanger. The fan will stop when the unit cools
down.
Other points :
Steam is discharged from the flue
terminal.
High efficiency appliances tend to discharge water
vapour on cold days. This is normal.
Timers :
Timers do not operate at set time.
Timers may either be unactivated or incorrectly
programmed. Repeat programming. Refer to
pages 14 and 15.
Timer operates for 30 seconds then cuts
out.
Room temperature may be higher than set
temperature. Adjust temperature upwards if
desired.
Heater does not start even when ON
button is pushed and thermostat is on
HIGH.
Check timer. Timer must be in the “OFF” position
for manual operation.
Smoke or strange smells are produced on
the first trial light up after installation.
This is caused by grease or oil on the heat
exchanger and dust, and will stop after a short time.
Sharp clicking noises at ignition, or when
the unit cuts down on the thermostat, or
goes out.
This is simply expansion noise from the heat
exchanger.
Summary of Contents for Energysaver RHFE-1004FTR
Page 33: ... 32 WIRING DIAGRAM ...
Page 34: ... 33 NOTES ...