– 25 –
TESTING
3. Fit the screw clamp between the sliding
tube and the flue elbow. Secure with the
4 mm screw supplied. The flue outlet is
now locked into position.
4. Slide the insulation sleeve up to the flue
manifold. slip the securing clip over the
sleeve as shown.
Testing Unit
Purge air and swarf from gas line. Connect gas.
Refer to A.G.A pipe sizing chart if in doubt
about the size of the gas line.
Connection can easily be reached from the top,
rear of the unit. Check for escapes, using soapy
water after turning gas on.
Remove outer case, 4 screws inside louvre, 2
behind louvre and 3 on the top rear of casing.
Remove test point screw, attach pressure
gauge to test point, (on solenoid valve).
Plug unit in and turn power on, (CAUTION-
230V inside unit).
Turn thermostat to “HI”, turn control to “ON”.
Unit should ignite within 10 seconds. (If unit
does not ignite first time it will spark again after
10 seconds).
If unit still does not ignite, there may be air in
the gas line, turn control “OFF” then “ON” again.
Check pressure, regulator is factory set, if
pressure is incorrect, check supply before
altering regulator.
Turn control to “OFF” position, remove pressure
gauge and replace test point screw.
Re-light unit, on “HI” setting.
Adjust temperature down Slowly.
The heater will cut down, then cut out
(Depending on the room temperature).
Turn the power off. Replace the casing.
Turn power on.
Re-check operation.
Replace top spacer, clipping the spacer into the
wall brackets at the same time as attaching it to
the heater.
Secure top spacer with the screws provided.
THE HEATER IS NOW SECURED TO THE WALL.
Flue Outlet tube
screw clamp
Fuel outlet
Sliding tube
Flue elbow
Locking Clamp L
Locking Clamp S
Manifold
Screw
Fit clip
Slide Insulation sock
Flue elbow
Flue outlet
Sliding tube
Slide to here
Sock
FITTING UNIT
Summary of Contents for Energysaver RHFE-1004FTR
Page 33: ... 32 WIRING DIAGRAM ...
Page 34: ... 33 NOTES ...