Installation and operating instructions for
Brake HS 215 FHM spring activated
–
hydraulically released
E 09.777e
Issue: 28.05.2021
Version: 2
Drawn: BAHS
Checked: EISF Pages: 28
Page: 14
2.4.2 Deactivate the manual release
The principle is to position the stopping rings in the piston groove once the pressure is applied.
They are fixed in position by 2 screws Fig. 2.8.
When the caliper is in operating mode, the rings are screwed to the cover in holding position.
Manual release in place
Manual release pending
Fig. 2.8
Refer to chapter 5.2 for more information about the manual release mode
Important!
The manual release must be deactivated to ensure a well running of the
brake.
2.4.3 Adjustments of pad gap
Important!
Contact are factory set and do not need any adjustment.
If necesary, follow the procedure chapter 5.3
Fig.2.9
First check the thickness of the disc. Use a set of
laminated shims to verify that total gap between the
pads and the disc is corresponds to the “PG“ Pad
Gap on the type plate.
The Pad Gap must be equal both side PG = (a+b)
