Passwords
It is strongly recommended that Passwords are set for access
to all router property pages in PeripheralVision® because of
the sensitive nature of the information that may be configured.
If required, access to set/change the information on the router
property page may be restricted using the Change Password
button. Click it to bring up the following window:
Enter New Password. Confirm Password and click OK.
Access to change the configuration will now be restricted to those
who have the Password.
Back to TOC.
Routing Table Page
7. It is now necessary to tell the router where to route the IP packets.
This is done by creating a Routing Table. Use the arrows to scroll
the pages and select the Routing Table page. Make sure that the
whole IP range is passed over to the other network. Any packets
that are not in this range will be passed onto the Default Gateway
Address. An example of this setup is shown in the following
diagram.
To configure each route, click the Add Route button and enter the
information as described:
RD2004112901 | Eth_Tring_Rout_Man.doc
- 9 -