The Red Error LED will light when there is an error on the Token
Ring network.
The Green RX LED will blink when the router receives data from
the Token Ring network.
The Red TX LED will blink when the router transmits data to the
Token Ring network.
Powering the Router
Connect the power cable to the Power Supply socket on the Rear
panel of the router. Connect the other end of the power cable to the
mains electricity supply.
Switch the router on using the Power switch on the rear panel.
Important Note
If there is a delay in connecting the router to the Token Ring
network after power-up, it may be necessary to restart the router in
order to make a good link to the Token Ring network.
When using PeripheralVision, you should see two (2) routers, each
representing a different side of the router (token ring and ethernet).
If you do not see two, use the Ping button to locate the second
router (default 11.22.33.44 and 11.22.33.45).
Back to TOC.
RD2004112901 | Eth_Tring_Rout_Man.doc
- 6 -
