Using PeripheralVision® to Configure the Router
Full operational procedures for PeripheralVision® are detailed in
the program helpfile, refer to this if any problems are encountered
in the procedure detailed below.
1. Install PeripheralVision® onto a PC on the Ethernet Network One.
2. Ensure the router is installed on both networks.
3. Using the Locate NPMP® discovery tool in
PeripheralVision®, enter the default set IP
address (11.22.33.44). The router will appear
on the network map, it will be an icon similar to
the example on the left.
4. Left click twice on the icon to open the property pages of the
device. The default displayed page will be the Name page. This is
shown below:
5. In the Icon Title field, enter a name for the router that will allow it to
be identified on the PeripheralVision® network map.
Back to TOC.
RD2004112901 | Eth_Tring_Rout_Man.doc
- 7 -
