RIKA PREMIO, Instruction Manual, Page: 23 / 36

9 . E L E C T R I C I G N I T I O N
EN
GL
ISH
23
PRE-HEATING WITHOUT ELECTRIC
IGNITION
➧
CAUTION: APPLIES ONLY TO STOVES WITHOUT
ELECTRICAL IGNITION
➧
If your stove is fitted with electric ignition and
this is faulty - please request a service or
repair visit!
If your pellet stove is not fitted with electric
ignition proceed as follows:
1.
Check that the pellet container is full and
the combustion chamber is clean and
free from impurities. Place approved
firelighters in the fire pan and lay a small
handful of pellets on top.
CAUTION: Do not use flammable
liquids to preheat the stove!
2. Light the firelighters in the fire pan using
a match and close the stove doors
carefully. Press the “ON/OFF” button.
This setting starts the start procedure.
30 kg of pellets should be sufficient for 16
hours of operation at a setting of “100%”,
and about 58 hours at a setting of “0%”
(there may be variations caused by diffe-
rences in pellet fuel).
If you have any questions please contact
your authorised pellet stove dealer
Pellet consumption depends on the size of the
pellets. The larger the pellets the slower the feed
and vice versa.
The pellet stove can be used in continuous ope-
ration without any concerns and free from risk,
however we recommend that you reduce the hea-
ting output overnight and when you leave the
room for a long period.
To prevent the fire from going out due to
lack of fuel, we recommend that an ade-
quate pellet level is kept in the storage con-
tainer. A 15 kg sack of pellets can be loaded
into your pellet stove as soon as the pellet
container is less than half full. Check the fil-
ling level often. The container lid should
however always be kept closed unless the
container is being filled.
Pellet container capacity (see technical spe-
cification).
CAUTION when filling the stove with pellets!
Do not touch the hot stove with the pellet sack.
Remove any pellets that have not been put in the
storage container immediately!
SOME FIELD VALUES
FUEL FEED
The pellet furnace is fitted with an electric
ignition.
This starts to function together with the
stove start program.
Ignition duty cycle: Approx. 12 min.
CAUTION: The storage container must only be fil-
led using the heat-resistant glove supplied!