RIKA PREMIO, Instruction Manual, Page: 14 / 36

ELECTRICAL CONNECTION
The stove is supplied with an approx. 2.5 m
long connecting cable with a plug. The
cable must be connected to a 230 V, 50 Hz
electrical supply. The average electric
power consumption is approx 100 watts
during heating. During the automatic igni-
tion process (duration 10 minutes) approx.
350 watts. The connection cable must be
laid so that any contact with hot or sharp-
edged external surfaces on the stove is
avoided.
COMBUSTION AIR
Each combustion procedure requires oxygen
or air. As a rule this combustion air is remo-
ved from the living area for individual stoves
The air taken from the living area must be
reintroduced. In modern houses, very tight
fitting windows and doors mean that too
little air flows back. This situation becomes
problematic due to additional ventilation in
the house (e.g. in the kitchen or WC).
EN
GL
ISH
14
Feed of external combustion air
➧ We recommend that steel tubes are
used.
➧ Minimum diameter 5 cm/2 inches.
➧ The pipe should not be longer than
approx. 4m to guarantee adequate air
feed and not have too many bends.
➧ Should the line lead into the open air, it
must end with a vertical 90
°
downward
elbow or with a wind guard.
Should one or more of these conditions
NOT be applicable then usually poor
combustion will occur in the stove, as well
as air underpressure in the apartment.
We recommend that a ventilating grille be
fitted in a window near the stove for
permanent ventilation.
Further it is possible to extract the com
bustion air directly from outside or from
another room that is well ventilated (e.g.
the cellar).
90
°
Termination
Termination
Wind hood
Minimum diameter 5 cm/2 in
Wall
150
Wall
50
70