|25
24
EN
General information
Note
Only work on the unit when the mains plug has been disconnected
and the stove has cooled down completely.
Note
During assembly / dismantling do not allow objects (screws etc.) to
fall into the pellet container – they can block the screw conveyor
and damage the stove.
Note
During any conversion work, take particular care of your fingers
and any panels and stove attachments. Select soft bases to
prevent scratches to your living space furniture and stove panels.
Q
The convection air amount and temperature is designed for
heating one additional room.
Q
Note the regional specific fire safety regulations and clarify the
connection situation with the competent authority.
Q
The max. temperature of the convection air is 180° C at the air
outlet.
Q
The convection air duct should be as short as possible.
Q
Keep the number of deflections as small as possible.
Note
Please pay attention to the national and country-specific building
and fire regulations when connecting the convection air pipes.
Installation and assembly must be performed by a trained
specialist only.
Delivery state stove Domo PGI
Removal of panelling
Attention!
Do not damage the flame sensor cable!
Remove the cable channel from the rear panel. Loosen the flame
sensor cable from the rear panel.
Loosen the 4 screws on the rear panel. The rear panel tilts backwards,
then you can lift it off.
#25
#25
