EN
|23
22
Attach the condenser (with 2 blowers both capacitors) in the free
slots behind the cable channel�
Loosen the nut and the ring from the capacitor till the end from the
thread�
In the cable channel are the three pin connector
M3
for the upper
MULTIAIR fan 1
and the plug
M4
for the lower
MULTIAIR fan 2
� Insert
the correct cable and put all cables and plugs back into the cable
channel�
Install the rear walls of the stove� It is mandatory to attach the motor
cover on the rear wall�
Note
Operation without a motor cover and without air duct is not allowed
for security reasons� Disregard voids your warranty and no liability
is accepted for damage�
Function test and settings
Connect the power cord back in and select the
Setup menu /
submenu
Service.
Perform a relais test to check the correct function
of the Multi Air fan�
Select the
Setup menu /
submenu
MultiAir fan.
Switch the
MultiAir 1
to
ON
and you will get access to fan speed and fan
adaptation�
Fan level
The volume of convection air is adjustable from AUTO (adapts
automatically according to heating power), over to Level 1 (min) and
level 5 (max)�
Fan area
In addition, it is possible to adapt the Multi Air fan speed (AUTO, level
1 to level 5) /- 30% of fan speed�
#13
Summary of Contents for CONNECT PELLET F22
