EN
|21
20
General information
Q
The convection air amount and temperature is designed for
heating one or, if two fans are installed, two additional rooms�
Q
Note the regional specific fire safety regulations and clarify the
connection situation with the competent authority�
Q
The max� temperature of the convection air is 180° C at the air
outlet�
Q
The convection air duct should be as short as possible�
Q
Keep the number of deflections as small as possible�
Note
Please pay attention to the national and country-specific building
and fire regulations when connecting the convection air pipes�
Installation and assembly must be performed by a trained
specialist only�
Note
Only work on the unit when the mains plug has been disconnected
and the stove has cooled down completely�
Note
During assembly / dismantling do not allow objects (screws etc�) to
fall into the pellet container – they can block the screw conveyor
and damage the stove�
Note
During any conversion work, take particular care of your fingers
and any panels and stove attachments� Select soft bases to
prevent scratches to your living space furniture and stove panels�
Mounting Convection Fan
Prepare the following at the stove:
Loosen the 2 hexagonal screws on the rear panel� The rear panel
tilts backwards� Disconnect the earthing cable� You can then lift it
upwards�
Depending on the desired option cut off the two upper markers for
one fan, for the second fan in addition the two bottom markers�
Note
The following steps are identical if you install a second convection
fan�
#8
I
II
Summary of Contents for CONNECT PELLET F22
