RI-1313-(2) Revision 1.0
5/3/2001
page 12
Main Container Closing -
- Ripcord and M.O.D. Handles
Step 1
“S” fold the main bridle and place on top of the main bag and
place the base of the spring pilotchute on top of the bridle.
Step 2
Collapse the pilotchute while stuffing the material in between
the coils. (
Figure 9
) The arrow on pilot chute cap should point toward
top of rig. Arrow indicates metal swage on pilotchute spring. Correct
orientation prevents unsightly wear on container flaps.
Step 3
Close the container in the numbered sequence. #1 - Bottom; #2 -
Top ; #3 - Right side ; #4 - Left side. Insert black plastic coated ripcord
cable through M.O.D. ring, if so equipped, (
Figure 10
) then through the
main closing loop. Stow the excess cable just under the top edge of the
left main flap. (
Figure 11
)
Note:
If the
Telesis 2
is set up for operation with an FXC AAD on the
main, the closing sequence for the last two flaps will be reversed. That
is, the right flap will close last.
- Throw-Out (T.O.P.)
Step 4
Route main bridle across top of bag and out upper right corner
of container See page 11 (
Figure 8)
.
Step 5
Close main flaps in the order stamped on each flap. #1 - Top;
#2 - Bottom; #3 - Right side; #4 - Left side. Pull flaps into place and
lock with the curved pin. Mate Velcro slack-tab and lay flat toward
top.
(Figure 12
)
Figure 9
Figure 10
Figure 11
Figure 12
