RF800 [Revision 1.0.0] 01.08.2018
Shafts Geometry Measurement Machine. RF800 Series
21
8. If the setting is incorrect, tap the
GoToEnd
button in order to move the
micrometer to the lowest position.
9. Screw the rack 1-2 turns.
10. Repeat steps 6-9 until the beam axis of the micrometer is on the axis of the
caliber.
11. Secure the rack by using the counter bush.
8.2.4. Template selection
Select the template from the list. The template that was used for calibration is
highlighted in blue.
After you select the template, tap the
Accept
button. The program will display the
parameters of the selected template:
In this window, you can see the following: the number of the shaft is РФ800.20.035,
the workplace is the D3 diameter control (highlighted in blue in the table and in the figure),
not QC (QC toggle is disabled). If the selected template is what you need, tap
Accept
,
otherwise go back to the previous window (tap on the blue arrow), and select another
template.
