RIEXINGER BSM 1000, Operating Manual

Page: 45 / 86

7. Operation 43
Information
The minimum space between workpiece and saw-band guide should not be
more than 50 mm; otherwise the quality of the saw-cut is compromised.
1) Press the emergency-off button so no one turns on the machine motor.
2) Load the machine with the workpiece to be sawed (see Chap. 7.8 on p. 38)
3) Turn on the star knob on the front an rear saw belt and adjut it (see Chap. 9.3 on p. 58)
4) Deactivate the emergency-off button .
7.10 Sawing
Danger!
Running saw band may cause serious severance injury!
Descending saw bow may pinch the operator!
l
The machine may only be operated by one person.
l
Before sawing, the operator must ensure that the area behind the work-
piece and the work area are clear.
l
Ensure that workpiece ist fasten well before sawing operation
Attention!
Falling, offcut workpieces may injure the operator!
l
Secure workpiece offcuts that are not clamped in (e.g. with suitable lifting
gear) so that these pieces do not fall from the table after sawing.
l
It is not permissible for the operator or the assisting person to hold or catch
the offcut piece.
1) Turn on the machine with the main switch (see Chap. 7.3 on p. 33)
2) If required, set the desired sawing angle (see Chap. 7.7 on p. 37)
3) Load workpiece into machine (see Chap. 7.8 on p. 38)
4) Set the saw feed rate (see Chap. 7.6 on p. 35)
5) If lamp Control on is not lit, then press it.
6) On the control panel press and hold both buttons of the Safe Ball with one hand. You must
keep these buttons pressed during the next two steps as the motors will otherwise stop abruptly.
l
The saw bow with the running saw band will move downward and execute the saw cut.
l
The motors stop automatically once the workpiece has been sawed and the saw bow has
arrived at the bottom position.
BSM 631 / BSM 800 / BSM 1000