RIEXINGER BSM 1000, Operating Manual

Page: 40 / 86

38 7. Operation
4) Ensure that there are no people or obstacles in the swivel range area of the saw frame.
5) Loosen the quick-tensioning lever on the saw-angle adjustment equipment.
6) Carefully and slowly swivel the saw frame in the appropriate direction until the reference
pointer shows the desired angle value on the angle scale.
7) Secure the set angle position of the saw frame by tightening the quick-tensioning lever.
8) Unlock the Emergency-Off-Button .
7.8 Loading the machine
Loading a workpiece into the machine
1) If the saw band is not raised, raise saw band up about 100 mm higher than the upper work-
piece edge.
2) Press the emergency-off button so no one turns on the machine motor.
3) For the processing of pipes with max. Ø 200 mm mount the V-Support (optional).
4) Place the workpiece onto the support rolls of the machine with the help of a suitable lifting
device and possibly another person.
5) Push the workpiece ahead as far as possible until the cutting line ist under the saw band.
l
The optical cut indicator shows the cutting line on the workpiece (optional)
6) If the workpiece can not bee safely clamped with minimum two tension belts, rotate the work-
piece by 180 degrees in order to clamp it securely to the longer side. or take a longer workpiece.
7) When the workpiece is so long that it falls down without clamping, then you will support the
outstanding workpiece end with suitable supports.
8) Set the movable support of the workpiece at the right side of the machine so that the work-
piece is supported as close to the cutting line. Be advised by angel cuts, that the saw band does
not collide with the movable support of the workpiece.
9) If necessary, set the space between saw band guide and workpiece (see Chap. 7.9 on p. 42).
10) Support protruding ends of long workpieces that tip down when clamped in.
11) Unlock the emergency-off button .
Remove workpiece from the machine.
1) If the saw band remains below the upper workpiece edge, raise up the saw band about 100
mm higher than the workpiece edge. Use button
Lift up .
2) Press the emergency-off button so no one turns on the machine motor.
3) Release both tension belts and remove them from the workpiece and remove the workpiece
and offcut from the machine with the help of a suitable lifting device and possibly another per-
son.
4) Unlock the emergency-off button .
BSM 631 / BSM 800 / BSM 1000