Riello DB 6 SM CO1 A0, Installation, Use And Maintenance Instructions

Page: 42 / 64

20
CHAPTER
6
Maintenance
Fault Possible cause Recommended remedy
The burner repeats the starting
cycle without lock out
• Mains gas pressure is near the value to which . . . . .Reduce operating pressure
the min. gas pressure switch gas is adjusted.. . . . . .of minimum gas pressure switch.
The repeated drop in pressure which follows . . . . . .Replace the gas filter cartridge
valve opening causes temporary opening of the
pressure switch itself, the valve immediately
closes and theburner comes to a halt. Pressure
increases again, the pressure switch closes again
and the firing cycle is repeated. The sequence
repeats endlessly. And so on.
During operation, the burner
stops in lock out
• Fault on air pressure switch . . . . . . . . . . . . . . . . . . .Replace
• Max. gas pressure switch operates. . . . . . . . . . . . . .Adjust or replace
Lock out when burner stops • Flame remains in combustion head or flame . . . . . .Eliminate persistence of flame
simulation or replace control box
Ignition with pulsation • Poorly adjusted head . . . . . . . . . . . . . . . . . . . . . . . .Adjust
• Poorly adjusted air damper, too much air . . . . . . . . .Adjust
• Output during ignition phase is too high . . . . . . . . . .Reduce