11
HYDRAULIKANSCHLÜSSE (Abb. 13)
Nach dem Anschluss des Versorgungsrings Brenner und BAG mit-
hilfe der beigepackten Schläuche und Nippeln anschließen; eine
Umkehr von Vorlauf und Rücklauf ist nicht möglich, da sie mit unter-
schiedlichen Gewinden ausgestattet wurden.
Die Anschlussrohre für Bag/Brenner sind Spezialrohre aus Teflon für
hohen Druck und hohe Temperaturen; ein Austausch der Rohre min-
destens alle zwei Jahre wird empfohlen. Sie können auch gegen
steife Rohrleitungen getauscht werden; in diesem Fall müssen sie
mit wärmeisolierendem Material geschützt werden.
Bei steifen Rohrleitungen lässt sich außerdem der Brenner auf den
Führungen nicht öffnen; für Wartungsarbeiten am Brenner müssen
sie daher abgenommen werden.
Die Pump- und Vorwärmeinheit (BAG) kann weiter entfernt installiert
werden als bei den beigepackten flexiblen Rohrleitungen erlaubt; in
diesem Fall steife Verlängerungen an der BAG-Einheit anbingen und
diese mit wärmeisolierendem Material schützen (es wird darauf hin-
gewiesen, dass sich bei jedem Meter Verlängerung eine Tempera-
turverringerung an der Düse um ca. 5°C ergibt, auch bei guter
Isolierung), und folglich die am elektronischen Thermostat einge-
stellte Temperatur erhöhen.
Es ist nicht ratsam die BAG-Einheit in einer größeren Entfernung als
2 Meter vom Brenner anzubringen.
Abb. -
Рис.
13
D1494
ГИДРАВЛИЧЕСКОЕ ПОДКЛЮЧЕНИЕ (Рис. 13)
Подключив питающий контур, подключите при помощи
входящих в комплект гибких шлангов и ниппелей горелку и
BAG; невозможно спутать линию нагнетания с линией
возврата, так на них предусмотрены две разные резьбы.
Соединительные шланги bag/горелка - это специальные
тефлоновые шланги для высокого давления и температуры;
рекомендуется заменять их по крайней мере раз в два года.
Шланги можно заменить также и жёсткими трубами; в этом
случае их следует защитить термоизолирующим материалом.
Кроме того, жёсткие трубы не позволяют выдвигать горелку
по направляющим; поэтому, для выполнения обслуживания их
придётся отсоединять.
Насосный
и
подогревающий
блок
(BAG)
может
устанавливаться и дальше, чем это позволяют входящие в
комплект гибкие шланги; в этом случае на него необходимо
установить
жёсткие
удлинители
и
изолировать
их
термозащитным материалом (помните, что на каждый метр
удлинения
температура
на
форсунке
понижается
приблизительно на 5
°
C, даже при хорошей теплоизоляции) и
увеличить
температуру,
введённую
на
электронном
терморегуляторе.
Не рекомендуется устанавливать BAG на расстоянии более 2
метров от горелки.