55
COMMISSIONING AND MAINTENANCE
REMOVING THE BURNER
Proceed as follows to remove the burner:
− Close the fuel shut-off cocks;
− disconnect the connector (1);
1
− Unscrew the fixing nut (2) and remove the burner;
− Pull the burner (3) out, taking care not to damage it;
2
3
− Place the burner in an upright position.
Reverse the above steps to reassemble.
REMOVING THE BLAST TUBE
Proceed as follows to remove the blast tube:
− Remove the screws (1) and remove the blast tube.
− disconnect the high voltage cable (2).
1
2
9
With the blast tube removed, check its front edge to make
sure that it is smooth, free from deposits, burns and dents.
Reverse the above steps to reassemble.
REPLACING THE NOZZLE
INSIEME EVOe 32 B/110 LN (*)
Nozzle type
0.65 80°HF Fluidics
(*)
Burner with oil heater
Remove the blast tube then proceed as follows:
− Clean the electrodes without removing the clamp;
− Hold the nozzle holder (3) steady with one wrench while
using a second wrench to remove the nozzle (4)
4
3
Summary of Contents for 20118250
Page 1: ...cod 20129503 rev 3 06 2019 INSIEME EVOe 32 B 110 LN EN INSTALLATION AND MAINTENANCE MANUAL...
Page 61: ...61...
Page 62: ...62...
Page 63: ...63...
