E
N
G
LI
S
H
Engine Rieju
Engine
16
6) REMOVE
the sliding stop screw for starting from clutch side (1/F-5).
7) REMOVE
the fixing screws of the plastic oil pump cap (1/F-6). Undo the screws securing
the oil pump to the cover; then remove the pump.
8) REMOVE
the cover/crankcase fixing screws (of which one M6x55 (2/F-6), that secure
the water pump cover and the relative clutch cover to the crankcase); now remove the
cover (3/F-6) and its gasket.
9) TAKE
the starter assembly OUT of its seat (only for versions with starter pedals),
bearing in mind that the any shim washers must be put in the same position when the com-
ponent is reassembled.
CAUTION: when disassembling this group, carefully check the position of the
pieces so as to reassemble them correctly afterwards.
10) UNDO
the screws compressing the clutch springs (1/F-7); then remove the clutch pla-
te (2/F-7) and the entire set of discs (3 /F-7); remove the disc pusher, the ball and the clutch
rod (1, 2, 3/F-8), which are housed in the centre hole of the change shaft.
F-6
F-5
F-7
F-8
