RIDGID R84082, Operator'S Manual

Page: 12 / 44

12 - English
OPERATION
 Remove the cap from the 30-pin connector and place in
the storage area located at the back of the cradle.

Insert the iPod (facing out) into the cradle. Make sure the
30-pin connector on the iPod is aligned with the 30-pin
connector in the cradle and that the iPod is pushed down
completely to ensure proper docking. The iPod should
begin to play automatically.
NOTE: Before inserting the iPod, choose the playlist (or
other group of items such as Album, Song, or Genre) on
the iPod you wish to listen to.

Rotate the adjustment knob at the back of the cradle
left or right as needed just until the face of the knob is
touching the back of the iPod.
NOTE: Overadjusting the knob could cause your iPod to
bend the 30-pin connector out of place. Stop adjusting
the knob as soon as it touches the back of your iPod.

Press the tabs on the front of the iPod cradle until the
cradle clicks back into place.

To protect the iPod from environmental hazards such as
dust, moisture, etc., the drop-down compartment door
must be closed and latched.

Use the buttons on the radio or the remote control to play,
stop, and cycle through your iPod playlist.
 The iPod will recharge while docked as long as the radio
is in iPod mode, even when the iPod is playing.

All iPod controls can be used normally while the unit is
docked, with the exception of the volume. Volume is
controlled through the volume control knob on the radio.
 Turning the radio off while the iPod is docked WILL NOT
turn the iPod off.

To remove the iPod from the dock, simply lower the cradle
and pull the iPod upward to disconnect.
 For complete operating instructions for the iPod, always
refer to the manual that was included with your iPod
model.
For non-docking iPod models, other MP3 players, and
CD players:

Press the MODE button until the AUX menu is highlighted,
then press Enter ( ).

Open the drop-down compartment door by pulling up on
the latch handle.

Make sure the cap is in place on the 30-pin connector.

Place the iPod/MP3 player inside the cradle as described
in the previous section.
NOTE:
CD players and some larger MP3 players will not
fit in the cradle. These items can be placed on the foam
padding on the inside of the compartment door. Do not
attempt to close the compartment door when using items
too large to fit in the cradle.

Connect one end of a 3.5 mm audio patch cord (maximum
8 in. long) to the iPod/MP3/CD player.
 Connect the other end of the 3.5 mm patch cord to the
AUX jack.
NOTE: Make sure that the audio patch cable is positioned
so that it is not pinched if the door is closed.
 The iPod/MP3/CD player must be on and in play mode
for sound to be heard through the speakers.

All iPod/MP3/CD player controls can be used normally
while connected to radio.
NOTE:
Volume for any device connected through the
AUX jack can be adjusted using the volume control for
that device or by using the radio’s volume knob.

Turning the radio off will NOT turn the iPod/MP3 player
off.

To protect the iPod/MP3 player from environmental
hazards such as dust, moisture, etc., the drop-down
compartment door must be closed and latched.
NOTE: Some MP3 players will not fit inside the cradle.
In those instances, you will not be able to close the
compartment door.

The AUX jack DOES NOT provide charging function.

For complete operating instructions for all iPod, other
MP3 players, and CD players, always refer to the manual
that was included with your model.