Emptying the Dust Drum
1. Unplug Power Cord from power
source.
2. Remove the Powerhead Assembly by
pulling outward at the top of the two
Latches.
3. Lift Powerhead Assembly from the Dust
Drum and set aside.
4. Empty Dust Drum into a proper waste
disposal container.
3. (Optional) Attach the Extension Wand
to swivel end of the Hose.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
Blowing Feature
Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Insert the larger end of the Tug-A-Long
Positive Locking Hose with Dual-Flex
into the Blowing Port of the Vac.
Engage the Hose Latch to the lip of the
Blowing Port. The Hose should snap
into place.
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before emptying
the drum.
!
OPERATION
10
Dust
Drum
Drum
Latches (2)
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
CAUTION: Wear a dust mask if
blowing creates dust which might be
inhaled.
WARNING: To reduce the risk of
injury to bystanders, keep them clear
of blowing debris.
!
!
!
Extension Wand
(Optional)
Swivel
End of
Hose
Hose
Blowing
Port
Tug-A-Long
Positive Locking
Hose with
Dual-Flex
SP7030-1 HD06000 HD09000 2018.qxp_HD0600 HD0900 3/7/18 1:55 PM Page 10
