RIDGID 47222, Operator'S Manual

Page: 17 / 67

2. Properly set-up pipe to ensure pipe is level and
square on the shoulder of the drive roll.
3. Engage hydraulic pump and bring groove roll (upper
roll) down until it contacts the pipe.
4. Tighten stabilizer roll until roll contacts the pipe.
Continue to tighten stabilizer one full turn after con-
tacting workpiece
(Figure 23).
Do not reach across pipe to adjust stabi-
lizer.
NOTE! If pipe “walks off” the drive shaft, tighten stabi-
lizer 1 /
2
turn.
Do not use the pipe stabilizer/nipple
bracket on 8
″
or shorter workpieces. Increases risk of fin-
gers being crushed in the grooving rolls.
918 Roll Groover
Ridge Tool Company 15
Figure 23 – Stabilizer Positioning
Accessories
Only the following RIDGID products have
been designed to function with the 918 Roll Groover.
Other accessories suitable for use with other tools may be-
come hazardous when used on this Roll Groover.
To prevent serious injury, use only the accessories listed
below.
NOTE! A Roll Set consists of a Groove Roll and a Drive Roll.
Catalog Model
No. No. 918 Accessories
48405 — Roll Set for 8
″
Sch. 40, Tool Box Included
48407 — Roll Set for 1 1 /
4
″
to 1 1 /
2
″
Sch. 10/40.
Tool Box Includes Drive Shaft, Bolt and Tools
48412 — Roll Set for 1
″
Sch. 10/40 and 1
1 /
4
″
to 1 1 /
2
″
Sch. 10/40.
Tool Box Includes Drive Shaft, Bolt and Tools
48417 — Roll Set for Copper (2
″
- 6
″
) Types K, L, M and DWV
59992 — 1
″
- 12
″
Stabilizer for Grooving Nipples.
For 918 w/300 Mounting Kit or 918-I
49662 — Tool Box
76822 — English Diameter Tape
76827 — Metric Diameter Tape
Pipe Stands (See Ridge Tool Catalog)
WARNING
WARNING
WARNING
www. .com
information@itm.com 1.800.561.8187