For the most up to date documents, bike models, additional information, instructional videos,
And more visit us at
Ride1UP.com
12
NOTE:
◆
THERE ARE TWO PEDALS INCLUDED IN THE BOX WITH YOUR BIKE. THE PEDALS SCREW INTO
THE ENDS OF THE CRANKS WITHOUT EXTRA NUTS, SCREWS OR PINS. FAILURE TO USE THE CORRECT
PEDAL ON THE CORRECT SIDE WILL RESULT IN A STRIPPED CRANK ARM.
◆
3.4 Detailed Torque Settings:
•
Crank Arms: 39nm (pre-installed).
•
Handlebar Clamp: 5-7nm (unless otherwise marked on stem). Tighten evenly in a cross pattern so
the gap at each bolt is the same.
3.5 Test and Adjust Front and Rear Brakes:
After Assembly, you must test your front and rear brake. You can then adjust them as needed. How you
install the front wheel and brake caliper can affect whether the disc brakes rub when first assembling. After
assembly, you may need to adjust the front and rear brake. Look in line with the brake pads and slowly
tighten the quick release axle while ensuring the rotor stays in the exact middle between the pads. The disc
rotor is one of the most exposed malleable components during shipping. If it is bent, it can be trued (bent
back) in most cases or replaced with a new disc rotor. If unsure how to properly adjust your brakes, please
check our website for a recommended video. If you are unable to access our website, you should take the
bike to your local bike shop for an assembly inspection and/or tune up. The bike shop will be able to inspect
the bike for safety and adjust your brakes.
4. Battery Connection & Removal
•
Insert the key into the battery key hole.
•
Turn the key in a clockwise direction (At 90 degrees) and remove the key.
•
The battery is heavy, use both hands to avoid dropping and damaging the battery.
•
Slide the battery backwards and off the bike.
•
Replace battery by sliding in towards the front, then insert the key and turn to lock.
•
Charging port is on the left side of the battery.
NOTE:
◆
ALWAYS KEEP THE CHARGER PORT COVERED TO PROTECT AGAINST MOISTURE, WHICH CAN
DESTROY THE BATTERY.
5. E-bike Basics & Care
5.1 E-bike Basics:
Your Revv 1 e-bike will arrive with a center LCD display, light controls next to the right grip, and functional
controls near the left grip.
