4
Installation
This section is intended for the dealer of the NoNa
+
.
This section describes the following subjects:
Installation requirements
Connecting the various components
In section "Step-by-step installation and commissioning instructions" on
page 34 you will find an overview of the steps. Use the Appendix: "Checklist
for step-by-step installation procedure" on page 69 to check that all steps
have been completed.
4.1
Installation requirements
This section describes the requirements for installing the NoNa
+
.
4.1.1
Dealer/installer requirements
The installation of the NoNa
+
and the other components, together with the installation
and configuration of the software, must be carried out by a qualified dealer. Ridder
Growing Solutions considers a dealer/installer to be qualified if that person meets the
following requirements:
The dealer:
has a broad knowledge of installation technology (hydronic and electronic).
can understand and carry out instructions in English.
is familiar with the contents of this installation and user manual.
4.1.2
Installation requirements
The following requirements apply to installing the NoNa
+
on site:
Make sure that the NoNa
+
is level.
Install the NoNa
+
on a hard surface that is able to support its weight.
Install the unit in a dry, dust-free location (1)
1
.
Check the ambient temperature. This should be between 5°C - 30°C (41°F -
86°F) (2).
Check the relative humidity (RV). This may not exceed 85%, without
condensation (3).
Make sure that the unit is not exposed to dripping or splashing water (4).
Avoid exposure to direct sunlight (5).
Avoid exposure to hazardous substances (6).
Avoid exposure to unnecessary vibrations (7).
1
The numbers refer to the numbers in Figure 4-1.
NoNa
+
32
Summary of Contents for NoNa+
Page 1: ...SV 2 4 15 05 2020 96000023 Installation and User Manual NoNa...
Page 70: ...Signature Date NoNa 70...
Page 71: ......
Page 72: ......