Checklist for step-by-step installation procedure
The table below can be used as a checklist for the installation and commissioning
procedure for the HortiJet Pro. The right column shows page references to the
relevant sections.
You can use the spaces in the left column to tick off each step as you complete it.
This procedure assumes that:
Synopta and the HortiMaX CX500 are installed.
the dealer is familiar with the CX Assistant.
Completed No.
Step
Section to see for
this
Installation
1
Water installation
Connect the HortiJet to the two
branches from the main pipe.
Connect the fertilizer supply
hoses to the dosing channels.
"Connecting water
supply (hydronic
installation)" on
page 26.
2
Electrical installation
Connect the power supply,
network cable, main irrigation
pump and external meters and
valves.
"Connecting electrical
components" on
page 27.
3
Where applicable: connect the extra
dosing channels, sensors and/or I/O
modules.
"Installing other
components" on
page 28.
Commissioning
4
Use the latest version of the software
for the CX Assistant, HortiMaX CX500
and Synopta.
"Updating software"
on page 30.
5
Software configuration
Create a configuration with the
CX Assistant.
Check the configuration.
Upload the configuration to the
IPC.
"Software
configuration" on
page 31.
6
Check the settings (for the controls
HortiMaX CX500) in Synopta.
"Software settings"
on page 36.
7
Calibrate the EC and pH sensors.
"Calibrating the
sensors" on page 37.
HortiJet Pro
52