SCANNER UNIT
26 July 2002
3-8
Reassembling the Front Scanner Wire
1. Pass the end with the ball [A]
through the left square hole
from the front.
2. Position the center ball [B] in
the middle of the notch, as
shown by the arrow.
3. Pass the ball end [A] through
the notch on the right.
4. Wind the end with the ring [C]
clockwise three times; wind the
ball end [A] counterclockwise
five times.
NOTE:
The two red marks [D]
should meet when you
have done this.
5. Stick the wire to the pulley with
tape, so you can easily handle
the pulley and wire during
installation.
6. Install the drive pulley on the
shaft [E].
NOTE:
Do not screw the pulley
onto the shaft yet.
7. Insert the ball end into the slit [F],
with the end going via the rear
track of the left pulley [G] and
the rear track of the movable
pulley [H].
B051R944.WMF
B051R945.WMF
[B]
[A]
[C]
[D]
[E]
[F]
[G]
[H]
