Ricoh M000, Service Manual

Page: 23 / 138

Electric Shock and Fire Safety Precautions
Failure to follow the following instructions could cause electric shock or potentially cause a
fire.
1. Use only the correct voltage, failure to do so could damage the printer and potentially
cause a fire or electric shock.
2. Use only the power cable supplied with the printer. Use of an incorrectly specified
cable could cause the cable to overheat and potentially cause a fire.
3. Do not overload the power socket, this could lead to overheating of the cables inside
the wall and could lead to a fire.
4. Do not allow water or other liquids to spill into the printer, this can cause electric shock.
Do not allow paper clips, pins or other foreign objects to fall into the printer these could
cause a short circuit leading to an electric shock or fire hazard..
5. Never touch the plugs on either end of the power cable with wet hands, this can cause
electric shock. When servicing the printer remove the power plug from the wall socket.
6. Use caution when inserting or removing the power connector. The power connector
must be inserted completely otherwise a poor contact could cause overheating
possibly leading to a fire. When removing the power connector grip it firmly and pull.
7. Take care of the power cable. Do not allow it to become twisted, bent sharply round
corners or other wise damaged. Do not place objects on top of the power cable. If the
power cable is damaged it could overheat and cause a fire or exposed cables could
cause an electric shock. Replace a damaged power cable immediately, do not reuse or
repair the damaged cable. Some chemicals can attack the coating on the power cable,
weakening the cover or exposing cables causing fire and shock risks.
8. Ensure that the power sockets and plugs are not cracked or broken in any way. Any
such defects should be repaired immediately. Take care not to cut or damage the
power cable or plugs when moving the machine.
9. Use caution during thunder or lightening storms. We recommend that this machine be
disconnected from the power source when such weather conditions are expected. Do
not touch the machine or the power cord if it is still connected to the wall socket in
these weather conditions.
10. Avoid damp or dusty areas, install the printer in a clean well ventilated location. Do not
position the machine near a humidifier. Damp and dust build up inside the machine can
lead to overheating and cause a fire.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA