Ricoh AP204, Operator'S Manual, Page: 294 / 301

Making Printer Settings with the Operation Panel
53
4
❖
❖ ❖
❖
Paper Type
Specify the paper type for printing as: Plain Paper, Thick Paper, or OHP.
Selecting OHP transparency as the paper type automatically changes the col-
or profile to OHP settings.
❖
❖ ❖
❖
Auto Tray SW (Auto Tray Switch)
Use this setting to tell the printer to automatically switch to the other tray
when it has the same size paper as the current tray when paper runs out while
printing.
To use this feature, the optional tray unit should be installed to your printer,
and paper having the same size and direction should be loaded in both the
standard and optional trays.
❖ ❖ ❖ ❖
Job Timeout
Use this setting to specify how long the printer waits before terminating a
print job when the printer doesn't receive the end of the current print job. You
can specify a time ranging from 0 to 999 seconds, or you can turn this feature
off (no time limit).
❖
❖ ❖
❖
I/O Timeout
Use this setting to specify how long the printer waits for more print data be-
fore ending its wait condition for data and terminating a job. The job is auto-
matically cancelled if no data is received for the specified time. You can
specify a time ranging from 0 to 999 seconds, or you can turn this feature off
(no time limit).
❖ ❖ ❖ ❖
Feed Timeout
Use this setting to specify how long the printer waits for the correct paper size
loaded, when paper runs out while printing. The job is printed with the paper
currently loaded if the correct size is not loaded within the specified time.
You can specify a time ranging from 0 to 999 seconds, or you can turn this fea-
ture off.
❖
❖ ❖
❖
Print Errors
Use this setting to specify if an error report should be printed when a Post-
Script error occurs while printing.
•
Off
No error report is printed when an error occurs.
• On
An error report is printed when an error occurs. It uses some of the VM
area to turn this feature on.
❖
❖ ❖
❖
KTalk Mode
This setting is not effective.
❖ ❖ ❖ ❖
Parallel IF1
Use this setting to specify the parallel interface timing. When “System De-
fault” is selected, the setting in the “System Menu” is used.