Ricoh Aficio SP 5100N, Service Manual

Page: 126 / 175

EDC (Engine Diagnostic Control) Mode
G186 5-8 SM
5.2.7 CLUTCH/ SOLENOID
These functions are to check a current state (normal or not) of the solenoids and clutches.
Usage
1. Press the arrow keys "
'
/
(
" until "Component Test / 4.Clutch/Sol Test" message is
displayed on the panel.
2. Press the "OK" key.
3. Press the arrow keys "
'
/
(
" to find a desired function (Refer to the table below).
4. Press the "OK" key.
5. Press the "OK" key to execute the function or the "Back" key to return to the previous
step.
Function
Function Name Description Display (LCD)
T1 P-up Clutch The clutch will run or stop.
T1 P-up Clutch
[ON] / [OFF]
T2 P-up Clutch The clutch will run or stop.
T2 P-up Clutch
[ON] / [OFF]
T3 P-up Clutch The clutch will run or stop.
T3 P-up Clutch
[ON] / [OFF]
T4 P-up Clutch The clutch will run or stop.
T4 P-up Clutch
[ON] / [OFF]
Bypass Clutch The clutch will run or stop.
Bypass Clutch
[ON] / [OFF]
Duplex Sol. The solenoid will run or stop. Duplex Sol. [ON] / [OFF]
ƒ
The procedure and content above may vary, depending on the situation.
5.2.8 FUSER CONTROL
This function is to check a current state (normal or not) of the fuser unit.