4
Rev 20A
Gate Opening Default Setting Information:
The gate motor will open the gate to the right-hand side as its default setting (refer to fig 1).
Before Installing:
Test the motor by plugging it into a power source and pressing the remote. You will see the motor
cog turn. When it stops, press the remote again to see it turn in the opposite direction. This will give you an understanding
of the way in which the motor will move the gate.
Note: Ensure that the motor is unplugged before proceeding with installation. Please keep fingers away from the
motor cog whilst it is turning.
If your gate needs to open from the other direction (to the left, refer to fig 2) your motor needs to be mounted
on the left-hand side as shown, a licensed electrician will need to switch DIP SWITCH 5 from OFF to ON (refer
to page 22) and swap over the CL & OP lines on the J10 terminal (refer to page 24).
Any works done to the motor must be completed whilst the power is off, and the motor is unplugged
Press the first/top button on the
remote.
The motor cog will turn counter-
clockwise, moving the gate frame.
The gate will then move in the set
direction. Default: right-hand open.
Left-Hand Opening:
Motor mounted on the
left-hand side
Fig 2
Fig 1
Default operation:
Motor mounted on the
right-hand side
