8
WLS-C Wheel Loader Scale
1.4
Angle Sensor Installation
Place the chassis and boom angle sensors as shown in Figure 1-16. They should both be horizontal with the
connector in the cabin direction.
Two sensors are necessary because the relative angle between the chassis and the boom is used to perform the
weighing computation.
Figure 1-16. Sensor Placement
1. Using two to three 1" beads, weld the angle sensor’s mounting plate to the inside of the support arm.
Figure 1-17. Angle Sensor Mounting Plate
2. Fasten the sensor housing and angle sensor to the mounting plate.
Mounting plate with angle sensor attached.
Mounting plate
