SST4 Washdown Printer
54
Visit our website
12. Gently peel off adhesive backing from the three square cable ties. The location of placement of the square cable ties
are noted on the bottom of the SST4 enclosure. Press the square cable ties firmly onto the enclosure bottom where
noted.
Figure 5-14. Secure Square Adhesive Cable Ties to SST4 Enclosure Bottom
13. Set the printer unit back down onto the printer base plate, lining up the four metal studs. Also ensure the ribbon cable
at the front of the printer is also out of the way when placing the printer back into the enclosure. Note the ground wire
location leading to the front of the SST4 enclosure. The wires should run between the side of the SST4 enclosure and
the metal standoff. This will eliminate the risk of wires being pinched.
Figure 5-15. Don’t Pinch Ground Wire
14. Secure the printer pad to the enclosure bottom by securing four nuts and tightening using a 3/8” socket.
Figure 5-16. Secure All Four Nuts Holding Printer Pad to Enclosure Bottom
Template location for square adhesive cable ties
Remove backing paper
