Page 28
CAUTION: Unplug the vacuum cleaner before servicing
1. Remove the nozzle cover as shown on page 10,
II. Maintenance, B. Removing Nozzle Cover
2. Carefully clip the zip tie that holds the wiring (Fig. A)
3. Remove the two screws holding the hall sensor assembly in place. (Fig. B)
4. Carefully remove the hall sensor connection plug from the PC board. (Fig. C)
5. Install the new hall sensor assembly using the two screws. Be sure to secure the PC board ground
wire to the hall sensor base as shown in Fig. D. The hall sensor pully should be positioned on top of
the belt as shown in Fig. B.
6. Insert the hall sensor connection plug back into the PC board.
7. Reassemble machine and test.
Fig. A
Fig. B
Fig. C
Fig. D
II. Maintenance
P. Replacing the Hall Sensor Assembly (RSL5, and RSL5C only)
