Page
24
/
41
4. Pull the recoil starter handle lightly until you feel resistance then pull it briskly 3-4 times. The
engine would normally not start at this stage.
5. Move the choke lever to “ Run” position. Pull starter handle to start engine.
4.5.1.2- Starting a warm engine
1. Set the choke lever to “ RUN” position.
2. Pull the starter handle until the engine starts.
4.5.2 – Stopping the engine
Depress either one of the switch to the stop position (”O” position) to stop the unit.
V. OPERATION
5.1- Intended use
This petrol leaf blower is designated with an engine displacement of 26 cm³.
The product is intended for:
-
Blowing to pile up dry leaf material.
The product must not be employed in areas where there is health endangering dusts or as a wet
blowing device.The product may only be used with the blowing pipe completely installed. Avoid wet
materials such as leaves and dirt, twigs, branches, pine needles, grass, earth, sand, mulch, cuttings, etc.
Do not use on wet lawns, grass areas or fields.For safety reasons it is essential to read the entire
instruction manual before first operation and to observe all the instructions therein.
This product is intended for private use only, not for any commercial applications. It may not be used
for any purposes other than those described.
5.2- Operating the blower
WARNING:
Never run the unit without the blower tubes installed or the air inlet cover
securely closed. Use of an improperly assembled unit could result in serious personal injury.
WARNING:
Do not place blower on top of or near loose debris or gravel. Debris may be
sucked into blower intake vent resulting in possible damage to the unit and could result in
serious personal injury.
