Page
13
/
27
worn.
•
This power tool is not recommended for polishing operations.
•
This power tool should be operated at the rated speed.
•
This disc diameter must be within the capacity rating of the tool.
•
Do not use accessories which are not specifically designed and recommended by the tool
manufacturer.
•
The arbor size of disc, flanges or any other accessories must be properly fit the spindle of
the tool.
•
Do not use damaged accessories. Before each use inspect the accessory for signs of worn. If
power tool or accessory is dropped, inspect for damage or install an undamaged accessory.
After inspecting and installing an accessory, position yourself and bystanders away from the
plane of the rotating accessory and run the power tool at maximum no-load speed for one
minute.
•
Hold the power tool only by the insulated gripping surfaces during operation, where the
cutting accessory may contact hidden wiring or its own power cord.
•
Never lay down the power tool until it comes to stop completely.
•
Do not operate the power tool near flammable materials.
•
Do not use accessories that requires liquid coolants (including water or any other liquids),
which may result in electric shock.
3.4- Kickback and related warnings
Kickback is the result of power tool misuse and/or incorrect operating procedures or conditions
and can be avoided by taking proper precautions as given below.
•
Maintain a firm grip on the power tool and position your body and arm to allow you to resist
kickback forces.
•
Always use auxiliary handle, if provided, for maximum control over kickback or torque
reaction during start-up.
•
Never place your hand near the rotating accessory.
•
Do not position your body in the area where the power tool will move if kickback occurs.
•
Use special care when working on corners or sharp edges… etc. Avoid bouncing and
snagging the accessory.
3.5- Specific safety instructions for grinding and cutting operation
•
Use only disc types that are recommended for your tool and the protective guard designed
for the selected disc.
•
The protective guard must be securely attached to the power tool and positioned for
maximum safety, so the least amount of wheel is exposed towards the operator.
•
Discs must be used only for their recommended applications. For example: do not grind
with the side of the cutting disc.
•
Always use undamaged disc flanges that are of correct size and shape for your selected disc.
3.6- Specific safety instructions for abrasive cutting operations
•
Do not “jam” the cutting disc or apply excessive pressure. Do not attempt to make an
excessive deep cut.
•
Do not position your body in line with or behind the rotating disc.
•
When the disc is binding or when interrupting a cut for any reasons, switch off the power
tool and hold the power tool motionless until the rotating disc comes to stop completely.
Never attempt to remove the cutting disc from the cut while the disc is still in motion,
otherwise kickback may occur.
•
Do not restart the cutting operation in the workpiece. Let the cutting disc reach full speed
and carefully reenter the cut.
