NOTE
: A new chain and guide will need to be readjusted after as little as 5 cuts. This is normal during the
break-in period and the interval between future adjustments will lengthen rapidly.
CAUTION: If a chain is too loose or too tight, the chain and saw bearings will wear out more
quickly. Study Fig. 3 for information on the correct cold tension (A), the correct warm tension (B) and a
guide for cases where the saw chain needs to be adjusted (C).
CAUTION: Chain too loose if more than 3 mm after applying force with finger as shown in Fig 3.
Fig. 3
Make sure the chain brake is disengaged.
Disengage the chain brake (A) by pulling it backwards. (Fig. 4A)
Fig. 4A
1. Loosen the side cover knob a few turns (Fig. 4B).
2. Tighten the side cover knob. The saw chain is properly tensioned (Fig. 4C).
Fig. 4B Fig. 4C
