Ribble IWOC ONE, Quick Start User Manual

Page: 14 / 16

11. Communication Fault
There’s a communication error with the remote control.
Please check the connector. If the problem persists, contact
Ribble for assistance.
12. Driver Error Undervoltage
Battery pack voltage is too low. Connect the charger.
13. Driver Error/Overtemperature (80°C – 100°C)
The bike is outside the permissible temperature range.
Switch the bike off and allow the drive system to cool down
to the correct range.
Restart the system. If the problem persists, contact Ribble.
14. Driver Error Overcurrent
The current being supplied by the battery pack is too high.
Temporarily reduce the amount of assistance being provided.
If the system locks, perform a full restart. If the problem
persists, contact Ribble for assistance.
15. Driver Error VDD Undervoltage
Battery pack voltage is too low. Charge the battery pack.
16-24. Power malfunction
Check the condition of the motor connector and ensure that
it is connected correctly, and the arrows are aligned. Power
up the bike and check to see if the LED has stopped flashing
PINK.
If the error persists, contact Ribble for assistance.
25. Component Malfunction
A new component has been detected that is not configured
for this e-bike system.
Contact Ribble to activate it.
27. NVMI Error Saved/Errors Lost
Error in the error database. Restart the bike.
If the problem persists, contact Ribble for assistance.
28. EMN Error/ Impossible Save Errors
Error database is full. Restart the bike.
If the problem persists, contact Ribble for assistance.
29. Battery Voltage Sensor
Battery pack sensor may be damaged. Restart the system.
If the problem persists, contact Ribble for assistance.
30. Over Current Protection
Current supplied by the battery pack is too high. Reduce the
assistance level. If the system locks restart the bike.
If the problem persists, contact Ribble for assistance.
31. Peak Over Current Protection
Current supplied by the battery pack is too high. Reduce the
assistance level. If the system locks restart the bike.
If the problem persists, contact Ribble for assistance.
34. ACC Voltage Error
Power supply problem in the HMI Bus.
Restart the system. If the problem persists, contact Ribble
for assistance.
35. Sensors 4V3 Error
Power supply problem in the sensors. Check the pedalling
(PAS) and Motor Sensor.
Restart the system. If the problem persists, contact Ribble
for assistance.
36. Lights V Error
Power output failure in the lights cable.
Restart the system. If the problem persists, contact Ribble
for assistance.
129 Demo Mode
Contact Ribble for this to be deactivated remotely.
193. Cell Over Voltage
Fully discharge the battery and then recharge it. Leave
the battery connected to the charger for two hours after it
reaches maximum charge to balance the cells.
194. Cell Under Voltage
Fully discharge the battery and then recharge it. Leave
the battery connected to the charger for two hours after it
reaches maximum charge to balance the cells.