RHINO RAMV2, Instruction Manual

Page: 29 / 40

29
3.3.3. Changing REGISTER 3
Vehicle Set Up: D
RIVER
’
S
D
OOR
O
PEN
, B
ONNET
O
PEN
, A
ND
T
HE
I
GNITION
T
URNED
O
N LAST
Remote Key action : T
URN
O
N
/ O
FF
F
EATURES
V
IA
T
HE
B
OTTOM
B
UTTON
O
N
T
HE
R
EMOTE
PROGRAMMABLE
FEATURE
Press
Remote This
Many Times
INITIAL
FACTORY
SETTING
DESCRIPTION
Call Phone 1 on no
response within 1
minute 1 ON Call phone number in memory location 1 if there
was known response to an alarm condition i.e. If
the system goes into alarm and you do not
respond with a message or disarm the alarm.
Door Lock on
Ignition 2 OFF When this feature is on, the doors will lock when
the ignition is turned to on, and unlock when the
ignition is turned to off.
2 Second Exit Delay 3 OFF When this feature is on, the normal 45 second
exit delay is reduced to 2 seconds ie the alarm is
fully armed 2 seconds after pressing the remote.
No Door Ajar
Warning 4 OFF When this feature is on, the door ajar warning
feature is removed (the siren & indicators will not
beep & flash for 3 sec. if a door is not closed
properly).
Perimeter Night
Light 6 OFF When this feature is on, the indicators will stay
on constantly for 20 seconds on disarm, or until
the ignition is turned on. This allows for
illumination around the vehicle at night.
Instant Boot Release 7 OFF When this feature is on, the boot release button
(left) will only require to be pressed once rather
than held down for 3 seconds to open an electric
boot.
External Pre-Warn
Output 8 OFF When on, the internal alarm pre-warn is disabled
& a two second output from the boot wire is
given.
PAT™ Past Alarm
Trigger Memory 9 SELECT
to replay
memory.
After pressing the remote 9 times to enter this
mode, turn the ignition off. Your Rhino Alarm
offers a unique memory that stores the ten last
reasons why the alarm was triggered. This
memory cannot be erased.
1 Beep, 1 Flash - Voltage Drop Alarm
2 Beep, 2 Flashes - Glass Break Alarm
3 Beep, 3 Flashes - Shock Sensor Alarm
4 Beep, 4 Flashes - Power Fail Alarm
5 Beep, 5 Flashes - Ignition Alarm
6 Beep, 6 Flashes - Aux Alarm
7 Beep, 7 Flashes - Door Alarms
8 Beep, 8 Flashes - Bonnet / Boot Alarm
If two previous alarms were recorded i.e.
voltage drop and shock sensor the LED will flash
and the siren will beep once for voltage drop,
then no noise for 1 second then beep three times
for shock sensor sensor. The last memory heard
is the most recent alarm sector triggered. Turn
the ignition to on to exit this mode.