RHINO RAMV2, Instruction Manual

Page: 28 / 40

28
3.3.2. Changing REGISTER 2
Vehicle Set Up: D
RIVER
’
S
D
OOR
O
PEN
, B
ONNET
C
LOSED
, A
ND
T
HE
I
GNITION
T
URNED
O
N LAST
Remote Key action : T
URN
O
N
/ O
FF
F
EATURES
V
IA
T
HE
B
OTTOM
B
UTTON
O
N
T
HE
R
EMOTE
PROGRAMMABLE
FEATURE
Press
Remote
This Many
Times
INITIAL
FACTORY
SETTING
DESCRIPTION
Left Button Used For
Another Vehicle 1 OFF Allows your remote keys to be divided to act like two
separate single button remote keys to control two
separate vehicles, i.e. left button controls vehicle
"A", Bottom button controls vehicle "B". Simply
“learn” the remote into the other vehicle as detailed
in section “learning new transmitters”. Only right
button features can be accessed. (i.e. boot release
control is unavailable).
Second Button Used To
Arm/Disarm This
Vehicle 2 OFF Turn this feature on in your second vehicle (not this
alarm system) if you are utilising the above feature.
Auto Immobilise
Override 3 OFF Turn this feature on to disable auto immobilise when
the vehicle is left disarmed for 40 seconds after the
ignition is turned off.
TransRAM mode
4 OFF When this feature is turned on then the TransTX
module may be interfaced to allow the user to arm
and disarm their vehicle via the factory remote
control. See the TransTX instructions for further
details. NOTE: If the TransTX was supplied with the
unit, then this feature is already turned ON by
default.
Silent Operation 5 OFF When on, this feature stops the siren from sounding.
The alarm will still trigger, flashing the indicators etc.
Indication via optional paging system may be
desired instead of siren noise.
Valet Mode 6 OFF When on, this feature allows five engine starts
before the system returns to its normal operation. Ie.
If you take the vehicle to valet parking, and you
normally use passive arming, they will be able to
start the car 5 times before passive arming re-
engages.
Central Closure 7 OFF When on, the lock outputs become a 15 second
negative pulse instead of 0.5 seconds. This feature
is for certain vehicles with vacuum central locking or
those with a central closure wire (some BMW,
Mercedes) i.e. doors lock, electric windows wind up,
sunroof closes automatically.
Wireless Keypad Mode
8 OFF When this feature is turned on then the Wireless
Keypad may be used to disarm the system while still
using the standard factory remotes to lock and
unlock the vehicle. See the Wireless Keypad
instructions for further details.
Installer Mode 9 SELECT
The Mode
Required
After pressing the remote 9 times to enter this
mode, turn the ignition to off. This mode allows the
installer / owner to verify that each trigger of the
alarm system is working, without having to arm &
disarm the system each time & set off the siren. The
siren will beep and the blinkers will flash to indicate
a trigger eg push the bonnet switch, open a door, hit
the vehicle. The siren will beep four times to indicate
a pre-warning impact sensor detection, or once to
indicate full alarm trigger level. Turn the ignition on
to exit this mode.