RHINO FC-0007, Operator'S Manual

Page: 98 / 160

OPERATION
SE6 05/05 Operation Section 4-6
© 2005 Alamo Group Inc.
OPERA
T
ION
2.3 Tractor Horsepower
The power required to operate a mower is determined by the tractor PTO horsepower. For most mowing
conditions, the SE5 mower requires a tractor with at least 20 HP. Operating the mower with a tractor that does
not have adequate power may damage the tractor engine. Exceeding 50 HP may cause mower damage by
overpowering the unit in heavy cutting conditions.
2.4 3-Point Hitch
The tractor 3-point hitch must be rated to lift at least
730 lbs.
The SE6 mower is designed to be mounted on a
tractor with a CAT I 3-point hitch. Refer to the
tractor operator’s manual for the category of the
tractor being used. If the hitch does not conform to
ASAE CAT I dimensions, the mower may not fit or
raise properly. Consult an authorized dealer for
possible modification procedures to mount non-
conforming hitches.
Depending on the hitch category, certain size pins
are used to attach the mower to the tractor. CAT I
hitches require 7/8” lower and 3/4” upper diameter
hitch pins.
CAT I Implement / Hitch Specification
Width from outside to outside A-frame.... 26 7/8”
Quick Hitch width inside lug to lug ......... 27 1/8”
Height from bottom hitch pin to top pin ... 18”
Lower pin diameter ................................. 7/8”
Upper pin diameter ................................ 3/4”
Lynch pin diameter ................................. 15/32”
2.2 Tractor Safety Devices
If transporting or operating the tractor and mower near a public roadway, the tractor must be equipped with
proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of
the unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor
warning signals are obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or mower. Never operate the tractor PTO with
the PTO master shield missing or in the raised position.
OPS-U- 0004