Assembly Instructions
22x24x12 Peak Style Two Car Garage
This step is key to good fit and to prevent door
movement in wind.
The rope channels should be located inside the unit, with
the frame members passing through the pre-cut slots in
the end panel/door. Replace and tighten the carriage
bolts after putting the end panel into position.
V2.3
7
Step 3.
Tie off one end of the rope coming out of the
end panel to a turnbuckle. Turnbuckle should be
loosened all the way and the open hook end attached to
the hole in the inside of the end arch foot. Hold the end
of the unsecured rope and apply pressure downward
with a foot to remove excess. Re-adjust gathered
material evenly along door rope. This step is key to
getting a good door fit. Tie off the end off the rope to a
second turnbuckle attached to a hole in the foot of the
end arch on the opposite side. The end panel can be
adjusted further by tightening the turnbuckles.
Note: Adjust/Snug the end panel by turning the
turnbuckles or repeating step 3 on a regular basis
MAIN COVER INSTALLATION
Step 1
. To elongate the life of Main Cover, put a small
square of duct tape (field supplied) over each bolt head
on frame that comes in contact with cover. The tape
acts as a cushion to avoid rubbing damage to the cover
over years. As an alternative, foam rubber pipe
insulation also makes a good cushioning material over
frame parts.
Unpack the Main Cover #MUC-7000 from the protective
plastic packaging. The line of grommets on the inside
(white) of the cover on the tie down Flap run parallel to
the sides of the frame assembly for positioning. Once
cover is oriented parallel to the side of the Frame
