Assembly Instructions
22x24x12 Peak Style Two Car Garage
Place the Drive Rod through the loop in the anchor
lanyard. Pull upward to set anchor head into the ground.
V2.3
6
ANCHOR STEP 3
Slip one side of the U-bolt through the eyelet at the end
of the anchor cable. Attach the cable to the Arch leg
upright with the U-bolt and tighten. Do not attach to base
cross rails. Ensure there is no slack in the cable. Slack
can be removed by wrapping the cable around the tie-
down rail.
EVERY
Arch
Upright
MUST be
anchored
END PANEL INSTALLATION
Note: Both End Panels MUST be installed before
installing Main Cover onto frame.
Step1
. Install One (1) End Panel Door w/Zippers (DZD-
6002) at a time to ends of the Frame assembly.
Remove Carriage bolts from the Top Ridge Rail, the two
Base cross rails, and the two side Cross Rails.
Step 2
. Place the end panel over the door over end
arch and wrap the material around the arch bringing the
vertical slits in the end panel to the inside of the frame
arch. End Door Panels have pre-cut slits that allow
frame members to pass through so rope pocket is inside
unit.
Place the top rail ridge pole and the side cross rails
through the material slits and replace the carriage bolts
and tighten. The door end will also require removal of
the wind brace bolts and placement of the wind braces
through slits in the ends panel. Reconnect wind braces
with carriage bolts once end panel is put into place.
Wrap Excess
Cable around
Frame
Member to
Draw Anchor
Connection
Tight
When putting on the doors, adjust the length to make
certain the doors do not drape onto the ground. Adjust
by pulling more or less material over the end arch
assembly. If pulling them up puts too much stress on
the slit where it goes over the wind brace, use a sharp
knife to cut slit another inch or two to relieve it. The PE
fabric is rip-stop weave, and can easily be cut to relieve
stress at the frame members.
Door assembly is drawn over frame by tightening rope
and securing to turnbuckles at the arch foot (Step 3).
Frame
must
be secured in position so it does not move
as end doors and main cover are tightened over frame.
