a connector that can accommodate the programming flash key
(see 09.05) or reading/writing terminals (see 05.28.) is available in
the right side of the cover;
in A machines, a door on the vending machine cover will enable
you to access to the internal water tank and fill it in;
an internal water tank is complete with a float signalling by means
of a red strip if you have filled it in excess;
product canisters dispense their content in the underlying mixing
bowls; an internal worm screw driven by the product motor will
push the instant product to the product slide; they can be equipped
with a wheel and a stirrer for constant dispensing; the outlet, the
dimension of which can be either standard or smaller, has got a
closing baffle; canisters are closed by a cover to protect products;
a water tank is intended to replace the last product canister on the
right in the releases not including the water connection with the
network (see 01.01.); this tank can be filled by means of a door on
the vending machine cover (see 05.13.);
the mixing bowls of the mixers will accommodate the instant
products you have poured to mix them with water; the fan of mixer
motors will act at the bottom and the drink outflow to the
dispenser occurs by means of a silicone tube; mixing bowls and
outlet tubes can be washed with lukewarm running water;
a fixed support on the cup station is intended to accommodate the
two dispensers coming from the mixing bowls;
the motors of mixers help to mix instant products with water by
means of the rotation of the fan mounted on their axis; the
rotation speed can be adjusted (see 09.01.a.) to the features of the
various products;
in A machines, the water load solenoid valve shall channel the
internal tank water to the underlying boiler;
they are intended to rotate the worm screws inside instant product
canisters to pour the product quantity necessary for selection in the
mixing bowls;
an aspirator will eject suspended product residuals from the
vending machine; the aspirator is connected with a drawer beneath
product slides to intercept the residual impalpable powder coming
from selections; the action time of the aspirator is programmable
by means of a software parameter (see 09.01.c.); aspirated air is
ejected through the slots of the rear panel;
to aspirate the air from the internal environment of the machine to
avoid any condensate;
05.13. flash key housing
05.14. water door
05.15. product canisters
05.16. mixing bowls
05.17. nozzle support
05.18. mixer motor
05.19. water load
solenoid valve
05.20. product motors
05.21. powder aspirator
05.22. air aspirator
15
16
17
18
13
19
21
20
22
14
MAN1890105 rel. 02 dated 08.03.2017
page no. 16 of 38
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: [email protected]
rheavendors group's sole property
XX micro by
