12.01. weekly
external body
cups station
product slides
dispensing system
walls and bottom of the
machine
internal wall of the door
12.02. monthly
environmental and
powder aspirators
products canister
12.03. yearly
dispensing system
products canister
powder aspirator drawer
boiler
silicone tubes
power off the machine; detach the power supply cable and
carefully make sure that there is no sign of wear; carefully check
the stability and efficiency of the internal connections of the mains
supply;
use a non-abrasive piece of cloth after having dampened it with
lukewarm water; only if necessary, use a neutral, non-foamy,
detergent;
attention
use neutral detergent products only; never use abrasive cloths,
steel sponges, aggressive or foamy detergents and other solvents,
hot water and acids;
extract the drip tray, remove the upper grilled cover and wash
them abundantly with water “A”; clean the seat of the drip tray and
the nozzles holder spout “B”; to remove the clamp of the cup
station, just press the two side hooks ;
remove them from the product containers, wash them abundantly
with lukewarm water (product slides are bayonet-fastened) “C”;
turn the fastening small levers of the mixing bowls “D” clockwise,
remove the dispensing nozzles “B”, pull the mixing bowl and the
powder suction ring; wash the assembly of disassembled parts
abundantly with lukewarm water;
remove any trace of residue from the internal surfaces of the
machine and clean by using a damp piece of cloth;
remove any trace of residue from the surfaces inside the door,
above all in the proximity of the cup station;
carefully make sure that the motors of the two aspirators can freely
rotate and have no obstacles or obstructions;
make sure that the corrugated tube connecting the powder
aspirator and the aspiration drawer is clean and free of any product
deposit “G”;
close the slides, remove the canisters from the machine, clean
them externally; clean the support surface carefully to remove any
trace of product;
replace the gasket at the base of the mixing bowl of the mixer;
remove the mixer motor fan by pulling it; replace the gasket of the
mixer motor shaft “E”;
disassemble the products canister from the machine; empty them,
disassemble them in their basic components and wash them
carefully “F”;
disassemble the mixing bowls; pull out the extraction drawers “H”;
wash them with plenty of lukewarm water;
empty the boiler by means of a drain pipe; extract it from the
machine, remove the cover and wash the tank by removing any
solid residue that may have built up at the bottom;
remove any calcareous deposit from active elements: temperature
probe, heating element, level probes, the shafts of rotary
pumps, …;
make sure that the water transport tubes are intact and that they
have kept their transparency, replace them, if necessary;
C
D
E
B
F
G
H
A
MAN1890105 rel. 02 dated 08.03.2017
page no. 34 of 38
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: [email protected]
rheavendors group's sole property
XX micro by
