8/10
LOCK
WASHER
D
E
STEP #2
MATTRESS SUPPORT ARM ASSEMBLY
STABILIZER RAIL ASSEMBLY
MATTRESS HEIGHT ADJUSTMENT
DETAIL D
DETAIL E
HEX NUT
PLAIN
WASHER
ALLEN BOLT
(D)
ALLEN
WRENCH
OPEN WRECH
HEX NUT
LOCK WASHER
PLAIN WASHER
MATTRESS
SUPPORT
STABILIZER RAIL
HARDWARE NEEDED FOR STEP #2:
ALLEN BOLT
(D)
ALLEN BOLT
(D)
ALLEN BOLT
(D)
ALLEN BOLT
(D)
ALLEN
WRENCH
Lock Washer = 8 pcs
Plain Washer = 8 pcs
Hexagonal Nut = 8 pcs
Open Wrench = 1 pc
Allen Wrench = 1 pc
(D) 1/4" x 1 1/4" Bolt = 8 pcs
STEP #2.1
Lay mattress support flat with stabilizer rail on each side.
NOTE:
On each end of the arm of the mattress support, there is a hole
for the bolt to pass through that corresponds to the holes located in the
frame of the mattress support.
STEP #2.2
Insert the bolt into the desired hole of the frame through the hole on the
arm support. Fasten the bolt with provided plain washer, lock washer
and hexagonal nut. Repeat procedure on other arms of the mattress
support. See
DETAIL D
WARNING:
Set the mattress support to the desired height by adjusting the support
arms. The mattress support should be at its highest setting for
newborns, then adjusted to the lower positions as the child grows and
becomes mobile. Once the child is able to stand, the mattress support
should be at its lowest position.
STEP #2.3
Install the stabilizer rail at ends of the arm support as illustrated in
DETAIL E.
Summary of Contents for LUCINE
Page 1: ...1 10 ...
