RGBlink RGB-RD-UM-4K, User Manual

Page: 15 / 51

4K Ultra HD NDI CAMERA User Manual
14
Chapter 3 Use Your Product
3.1 Remote Control
3.1.1 Match Code for Wireless Remote Control
One to One Code Matching:
Press the "set" and "*" keys combined for 3 seconds, LED indicator starts flashing. Camera
receive the signal and power on, LED indicator will go off if code matching successfully. The
camera can be controlled by this wireless remote control only after one to one code pairing.
Otherwise please clear the code matching of this remote control, or use other remote
control to pair with the camera again.
If one to one code matching failed, the red LED light flashes for 20 seconds and then goes off,
camera will stop code match and turn on sleep mode; Press any key to wake up the camera
and re-match code.
Note: After code matching successfully, please select the camera address to control it.
Clear Code:
Press the "set" and "*" keys combined for 3 seconds, LED indicator starts flashing. Camera
will power off and on, the LED indicator will go off if clear code successfully.
Sleep Mode and Wake Up:
Press any key to wake up the camera from sleep mode.
3.1.2 Keys Introduction for IR Remote Control
1) In this manual, “press the key” means a click rather than a long-press, and a special note will be given if a
long-press for more than one second is required.
2) When a key-combination is required, do it in sequence. For example,“
【
*
】
+
【＃】
+
【
F1
】
”means press“
【
*
】
first
and then press
“
【
#
】
”
and last press
“
【
F1
】
”
.
1.Standby Key
The camera enters standby mode if long press 3s on standby key;
Long press 3s again on the standby key, the camera will self-check again and return to HOME position (If preset 0
position is set, the camera will return to preset 0 position).
2. Camera Selection
Select the camera address to control