RFL Electronics RFL 9660, Instruction Manual, Page: 99 / 312

Esc -Abort command
H -Help
D -Run diagnostics
I -Port information
Q -Quit session
Port#/Label -Port selection
P -Program port
C -Configure switch
S -Save changes
R -Reset port parameters
U -Update hardware configuration
MODEM -Connect local port to modem port
RFL 9660 RFL Electronics Inc.
August 18, 1998 5-2 (973) 334-3100
LOCAL>_
Figure 5-1. Typical super-user command list display
H - HELP
The "H" command lets you view a list of all the commands you can use when you
are logged on as a super-user. These include the general access commands
described in Section 5, and the commands described in this section.
Format: LOCAL> H [ENTER]
This command tells the RFL 9660 to send a list of all super-user commands to your
terminal. A typical super-user command list appears in Figure 5-1. This is similar to
the general access command list described in Section 4, but it contains more
commands.
P - PROGRAM PORT
You can view detailed information about any of the RFL 9660's I/O ports by using
the "P" command.
Format: LOCAL> P [ENTER]
The RFL 9660 will return a prompt asking you for the port number.
Port #
If you enter a zero for the port number, the RFL 9660 will allow you to set the site
ID. The following prompt will appear:
Site ID
Old label was
old label
Please enter new label, up to 30 characters. _
Type in the desired site ID, and press the [ENTER] key when you are finished. Your
regular prompt will return.