RFL 9660
RFL Electronics Inc.
April 24, 2007
13-12
(973) 334-3100
Command:
\Nn
Error Correction Mode Selection
Values:
n
= 0–5, or 7
Default
:
3
Description:
\N0 Non-error correction mode with data buffering (buffer mode; same as
&Q6
).
\N1 Direct mode. \N2 MNP reliable mode. If the modem cannot make an MNP
connection, it disconnects.
\N2 MNP reliable mode. If the modem cannot make an MNP connection, it
disconnects.
\N3 V.42/MNP auto-reliable mode. The modem attempts first to connect in V.42
error correction mode, then in MNP mode, and finally in non-error correction
(buffer) mode with continued operation.
\N4 V.42 reliable mode. If the modem cannot make a V.42 connection, it
disconnects.
\N5 V.42, MNP, or non-error correction (same as
\ N3
).
\N7 V.42, MNP, or non-error correction (same as
\ N3
).
Command:
\Qn
Flow Control Selection
Values:
n = 0, 1, or 3
Default:
3
Description:
\Q0 Disable flow control (same as
&K0
).
\Q1 XON/XOFF software flow control (same as
&K4
)
.
\Q2 CTS-only flow control. Not supported
.
\Q3 RTS/CTS hardware flow control (same as
&K3
)
Command:
\Tn
Inactivity Timer
Values:
n = 0, 1–255
Default:
0
Description:
Sets the time (in minutes) after the last character is sent or received that the
modem waits before disconnecting. A value of zero disables the timer. Applies
onl
y
in buffer mode
.
Note:
You can also set the inactivity timer by changing the value of
S30
.
Command:
\V
n
Protocol Result Code
Values:
n = 0, 1, or 2
Default:
1
Description:
\V0 Disables the appending of the protocol result code to the DCE speed.
\V1 Enables the appending of the protocol result code to the DCE speed.
\V2 Same as
\V1
.
Command:
\X
n
XON/XOFF Pass-Through
Values:
n
= 0 or 1
Default:
0
Description:
\X0 Modem responds to and discards XON/XOFF characters.
\X1 Modem responds to and passes XON/XOFF characters.
Note:
This is also controlled via
&E6
and
&E7.
Command:
-Cn
Data Calling Tone
Values:
n
= 0 or 1
Defaults:
1
Description:
-C0 Disable V.25 data calling tone to deny remote data/fax/voice discrimination.
-C1 Enable V.25 data calling tone to allow remote data/fax/voice discrimination.