When using foot assembly, please pay attention to the following:
●
Forces acting on the motor feet that are transferred from a
gearbox are not permitted.
Forces that are acting via the gearbox shaft must be suppor‐
ted on the gearbox.
●
Improper installation results in forces that can quickly lead to
motor damage.
●
Check whether you can use "flange assembly" as an alter‐
native.
6.1.3
Attaching Transmission Elements
Fit and pull off the transmission elements such as pulleys and couplings only
with suitable equipment; heat them, if necessary.
Avoid unallowed belt tensions. Take the allowed radial and axial forces
specified in the project planning manuals into account.
The balance of transmission elements must comply with the balancing type
of the motor.
Motor damage due to strikes onto the motor
shaft
NOTICE
Do not strike the shaft end and do not exceed the allowed
axial and radial forces of the motor.
Fitting
Fig.6-4:
Fitting the transmission element
Use the centering hole for fitting transmission elements. For details on the
center holes, please refer to the Project Planning Manual
Rexroth Indra‐
Dyn A. If necessary, heat the transmission element.
DOK-MOTOR*-MAD/MAF****-IT01-EN-P
Rexroth IndraDyn A Asynchronous Motors MAD / MAF
Bosch Rexroth AG
35/67
Assembly
